Airtel Broadband: Beetel 110BX1 settings

[Boot_Comp]

Hi,I was trying to change the default password on my Airtel DSL router (Beetel 110BX1) but see that every time I make any change (even change in any settings) and then try to browse any website, instead of the site opening I always get the activatemyairtel website instead. Is there any way to avoid this every time I make a change? Also is there any specific procedure we need to follow when we make changes to the router settings?

 

[essbebe]

In Diagnostics disable client TR_069.

 

[Boot_Comp]

Thanks will try that.BTW what does this do?

 

[essbebe]

Functions supported by TR-069: * Autoconfiguration and dynamic service activation o initial CPE configuration** o remote CPE configuration * firmware management o version management o update management * status and performance control o logfile analysis and dynamic messages o diagnostics o connectivity and service control.

 

[bbzap]

I have the same problem. I have configured my modem to use both Airtel & BSNL. Initially it worked fine. But when I tried to access using Airtel connection the Airtel DSL activation page appears. I tried disabling TR-069 client and did Save & Reboot. But still the same.I even tried to remove all the WAN settings and created afresh, still the problem persists. Any other solutions?

 

[Mac]

restore factory settings and then retry with a new WAN connection.:thumbsup:

 

[bbzap]

Thanks. After lot of trial and error it worked.