The Syrotech device that I mentioned in this post does not support omcicli, so I could run the commands to check the VLAN tagging. Then, I found this YouTube video that shows how to enable Bridge Mode in the Airtel router that I have. I did that and it worked, so for now I will continue using bridge mode. Thank you all for your help!
-
Amazon Deals - ToS - Like us?
Airtel Fiber Connection with Syrotech GPON device
- Thread starter object08
- Start date
- Replies 18
- Views 408
- Messages
- 148
- Location
- Hyderabad
- ISP
- Airtel X (200 Static IP+40Mbps), Excitel Fiber (300Mbps), ACT Fiber (75Mbps), Jio Fiber (30Mbps)
- Messages
- 148
- Location
- Hyderabad
- ISP
- Airtel X (200 Static IP+40Mbps), Excitel Fiber (300Mbps), ACT Fiber (75Mbps), Jio Fiber (30Mbps)
D
Deleted member 87056
TP-Link XZ000-G3 works without any issues for my Airtel connection. Use the VLAN Tagging mode in the ONU itself or set VLAN on the router. I got it for 1380 inc. shipping from LT Store.
Here's the buy link : G3
If you want a little future proofing, go with the VSOL V2802RH, it's a little difficult to get it in India tho.
VSOL V2802RH is a bit more customizable, just like a SFP Module, you can change a lot of settings like SW version etc which cannot be changed by default on the TP Link G3. I saw a YT video where the guy was on some unlocked firmware but not sure how he achieved that.
Link to the video: video
In that particular firmware he was able to change a lot of settings including firmware version.
Airtel just checks GPON SN for authentication as of now but might check other things like SW version in the future. Tata Play Fiber checks a lot of parameters before authentication so devices like G3 doesn't work with it.
For Airtel, G3 works flawlessly as of now so you can go for it.
Here's the buy link : G3
If you want a little future proofing, go with the VSOL V2802RH, it's a little difficult to get it in India tho.
VSOL V2802RH is a bit more customizable, just like a SFP Module, you can change a lot of settings like SW version etc which cannot be changed by default on the TP Link G3. I saw a YT video where the guy was on some unlocked firmware but not sure how he achieved that.
Link to the video: video
In that particular firmware he was able to change a lot of settings including firmware version.
Airtel just checks GPON SN for authentication as of now but might check other things like SW version in the future. Tata Play Fiber checks a lot of parameters before authentication so devices like G3 doesn't work with it.
For Airtel, G3 works flawlessly as of now so you can go for it.
D
Deleted member 87056
Not sure, never heard of them. You can get the G3 if you want to save some money and don't need the 2.5G port.
@shivammangla HG8120C should work perfectly fine and it does not have VLAN related issues faced by other ONTs with ALCL OLT.