Getting IPV6 address outside Router also.

[nishantt6969]

Source

 

[nishantt6969]

Source

 

[nishantt6969]

how should I configure both ipv4 and v6 ?

I think only Huawei users can create multiple wan profiles. Try to get huawei ont if possible.

 

[Rickysin]

Thanks for the steps @nishantt6969
Yes Nokia router does not allow same vlan for different profiles

 

[Rickysin]

in my Nokia router i did following:

1. Deleted existing profile
2. Created ipv6 profile, with this i got ipv6 ip and internet was running but ipv4 only sites were not opening. Only ipv6 websites were working fine
3. Then i created ipv4&v6 combined profile, in this ipv6 was showing was linking and no ip was generated

So i think firmware update is required

 

[markiv]

9 years down the line a patch will be released after which systems will stop supporting IPV4 so everyone has to move to ipv6 gradually.

 

---

[Md Faraz]

thanks for your help bro but unfortunately it's not working :'( still says disconnected. I think maybe it's not supported in my current gateway.

Screenshot-2021-07-17-16-19-41-477-com-android-chrome hosted at ImgBB

Image Screenshot-2021-07-17-16-19-41-477-com-android-chrome hosted in ImgBB

ibb.co

Screenshot-2021-07-17-16-20-11-244-com-android-chrome hosted at ImgBB

Image Screenshot-2021-07-17-16-20-11-244-com-android-chrome hosted in ImgBB

ibb.co

Screenshot-2021-07-17-16-20-26-983-com-android-chrome hosted at ImgBB

Image Screenshot-2021-07-17-16-20-26-983-com-android-chrome hosted in ImgBB

ibb.co

Screenshot-2021-07-17-16-24-17-114-com-android-chrome hosted at ImgBB

Image Screenshot-2021-07-17-16-24-17-114-com-android-chrome hosted in ImgBB

ibb.co

 

[demifiend9]

I think only Huawei users can create multiple wan profiles. Try to get huawei ont if possible.

Can you tell what firmware version your huawei ont is in? Asking because my huawei ont doesn't have a "Internet" service type, it's TR069_Internet, and since the ipv4 profile is using tr069_internet, I can't use it on ipv6.

 

[demifiend9]

Source

You should set address/prefix assignment mode to slaac, that's the way it's set up by airtel by default. Choosing dhcpv6 there would prevent android devices from getting ipv6 as they don't support dhcpv6.

 

[Md Faraz]

@demifiend9 slaac only in "address/prefix assignment mode" or in "other information assignment mode also" ? And what about the one in WAN settings (pic) ?