How to authenticate TP-Link ONT bypassing JioFiber Router?

tr1k0N4 · 2024-09-27T13:42:21+0530

@yashgarg1803 on whose advice did you buy an XZ000-G7 for Jio? I hate to tell you this but that person is your enemy, not a friend, since G7 doesn't work with Jio at all

cruzeee · 2024-09-27T13:44:44+0530

@tr1k0N4 rip, which XPON works with Jio then? The XPON shows me "Registered (O5)" state right now but can't get IP address on Router :/

Zuke · 2024-09-27T14:01:42+0530

@yashgarg1803 XZ000-G3 V1/V2 works.

cruzeee · 2024-09-27T19:17:56+0530

@Zuke do we need to use some custom firmware on G3? I'll order the G3 if I get all the steps correct first this time

Zuke · 2024-09-27T19:20:22+0530

@cruzeee I did not need any custom firmware to make my G3 V2 work with JioFiber. One thing I did notice though is slow upload speed. It is fine until about 300 Mbps but not good for 500 Mbps and 1 Gbps plans. Download speed is fine though.

cruzeee · 2024-09-27T19:40:03+0530

@Zuke thanks for the info, did you buy it from ltonlinestore? I can see this one -> TP link XZ000-G3 1-Port Gigabit GPON Terminal – Rs.1290 – LT Online Store, is this the same v2?

IfranAli · 2024-09-27T19:44:03+0530

@Zuke true, I also have 1Gbps plans and barely get 300Mbps upload, whilst maintaining 850-900Mbps of download speeds.

Zuke · 2024-09-27T19:51:41+0530

@cruzeee Yes. Bought from there and they shipped V2. Some people here mentioned that V1 is no longer in stock.

cruzeee · 2024-09-27T19:56:50+0530

@Zuke thank you for the help, I'll also get that one and just to be sure I need to follow these steps right:

Okay sure, here is as detailed below for following steps to run third party ont without Jiofiber router...

Jiofiber have GPON SN and Password still accessible via telnet...

On TP-Link ont web ui:-
1) Change GPON SN.
2) Change gpon password.
3) Set vlan default settings (control via OLT).
4) Save it and check PON light because tplink is now bridge mode so you need to connect another router.

On Another router need to clone your VLAN and Mac Address web ui:-
1) Clone the Router MAC address.
2) Add and then Clone the Internet GPON VLAN ID.

Do I also need to modify the Software Version and other settings like Vendor Id etc?

Zuke · 2024-09-27T20:11:00+0530

Just follow that post. For VLAN, set it as 1015. That's all you need to do.