rajujayaraman
Newbie
Hi, I have internet access using D-Link wizard configuration and while I diagnize with the test page in router, I have fail mark on the two adsl settings.
It is in the ATM settings , I suppose,
Can I use this method given in the link to configure my router
the link
www.netvuze.com
P.S: I do not find these menus in my router. my router has vertical main and horizontal side menus.
could some one post a link that would fit my router menus
If this is correct, then I may change it to , as shown in the link.
what is this fail in adsl connection
Moreover, when I used the dsl dlink 2730 wifi router, the adsl diagnostic pages are self updating to the time as in the case of status page, but here I found the page as blank and it populate only when I click the test button and then blanks itself. It is having useful information such as attainable dwnload and upload speed data whenever you test it my just opening the router page.
It is in the ATM settings , I suppose,
Can I use this method given in the link to configure my router
the link
DSL Broadband Modem Configuration : Dlink 2730U/2750U with WiFi setup
Dlink 2750U / 2730U modem router complete installation and configuration guide- Internet/WAN configuration, WiFi Set up
could some one post a link that would fit my router menus
If this is correct, then I may change it to , as shown in the link.
what is this fail in adsl connection
Moreover, when I used the dsl dlink 2730 wifi router, the adsl diagnostic pages are self updating to the time as in the case of status page, but here I found the page as blank and it populate only when I click the test button and then blanks itself. It is having useful information such as attainable dwnload and upload speed data whenever you test it my just opening the router page.
Last edited: