Mikrotik IPV6 settings SLAAC on PPPoE

[markiv]

Hi,
can anyone guide me to set ipv6 on Mikrotik for mach1 on pppoe. IPV6 works fine with TP-Link on SLAAC but cannot get it working on mikrotik. Mikrotik Device as such receives ipv6 but connected devices are on ipv4 only.

 

[markiv]

/ipv6/dhcp-client/print Columns: INTERFACE, STATUS, REQUEST, PREFIX# INTERFACE STATUS REQUEST PREFIX 0 pppoe-out1 bound prefix 2404:bd00:3:zzzz::/64, 2d23h59m56s

/ipv6/address/print Flags: D - DYNAMIC; G - GLOBAL, L - LINK-LOCALColumns: ADDRESS, FROM-POOL, INTERFACE, ADVERTISE, VALID# ADDRESS FROM-POOL INTERFACE ADVERTISE VALID 0 G 2404:bd00:3:8810::/64 client bridge yes 1 D ::1/128 lo no 2 DL fe80::8cbe:2314:0:8/64 pppoe-out1 no 3 DG 2404:bd00:3:zzzz:zzzz:zzzz:0:8/64 pppoe-out1 no 2d23h59m12s

/ipv6/pool/print Flags: D - DYNAMICColumns: NAME, PREFIX, PREFIX-LENGTH, EXPIRES-AFTER# NAME PREFIX PREFIX-LENGTH EXPIRES-AFTER0 D client 2404:bd00:3:zzzz::/64 64 2d23h58m48s

/ipv6/nd/print Flags: X - disabled, I - invalid; * - default 0 * interface=all ra-interval=3m20s-10m ra-delay=3s mtu=unspecified reachable-time=unspecified retransmit-interval=unspecified ra-lifetime=30m ra-preference=medium hop-limit=unspecified advertise-mac-address=yes advertise-dns=yes managed-address-configuration=no other-configuration=no

 

[markiv]

@Lolita_Magnum i have shared details in above post

 

[Lolita_Magnum]

Change the pool name from client to something else, and under dhcp-client make sure address and prefix is marked.

 

[markiv]

things were correct needed minor modifications as below
Dhcp-client only prefix is marked

• First, turn back on IPv6 Forward under IPv6 → Settings.

ipv6 settings set forward=yes

• Then because you use PPPoE for your WAN, which is point-to-point, you should not set add-default-route=yes in your DHCPv6 Client setting. Turn that off because the default gateway is already the other peer of the PPPoE tunnel.