Netgear DG834G V3

[ansfarid]

I bought a new ADSL2 Wireless Modem+Router Model Netgear DG834G V3 and i had configured it to work with MTNL Triband, it works also but each and every 20 second connection is being reset automatically. can anybody will help me where i am going wrong.

 

[essbebe]

DG834v1 Support Page
check :a firmware update required or not.
In the modem see if you have selected "always on "

Reference :Find answers to your questions about TalkTalk in Help & Support
FAQ 15 to 19 for Netgear.

 

[viralbug]

^ please do not use the above link essbebe gave you. that is for the v1 router.
for the v3 router the webpage is Netgear DG834Gv3 Support page
upgrade your router to the latest firmware.
i dont think there is any problem with the firmware. i have the same router and have used MTNL without any problem with the last couple of firmwares.
check if you have missed out anything.

 

[essbebe]

@viralbug
DG834Gv3 Support Page . link error regretted.
Latest firmware : version Version 4.01.37 (for outside NA)
Mar 24, 2008

Link given by you:
https://broadband.forum/Netgear%20DG834Gv3%20Support%20page DEAD PAGE./LINK

 

[viralbug]

^ i was being lazy.
here are a few settings.
ADSL Settings
Multiplexing Method LLC-BASED
VPI 0
VCI 32
DSL Mode Auto (Multi-mode)
other than that, under WAN setup the MTU size should be 1492.
turn on NAT under basic settings.
turn on upnp.

also if you are using wifi, chack to see if you are in range and the signal is good.

 

[kanishka]

there will be logout every 20 sceonds then u turn it to 0 seconds in u Router Settingsthis evry where in Netgear product ok 192.168.1.1

 

---