TP Link Archer C6 V3 loses internet connectivity multiple times

[wheatbread]

Don't use random people's binary. You build it yourself it's not that hard anymore and you can change config before compressing too.

 

[Aashish.007]

I've built it using chef.openwrt but if you don't trust me np... can build by yourself!

 

[Fibrous]

Thanks guys. I am on the learning curve here so I will experiment a bit. @wheatbread any site you recommend to build this?

 

[wheatbread]

Just use the snapshot build, give it internet access via dhcp, ssh and install luci.
Watch any walkthrough tutorial.
Source

Upgrade to next service release whenever it comes out, it'll have your device in stable builds or you can use the chef "builder" service, just add luci in packages. It's at OpenWrt Firmware Selector same project that packages images for attendedsysupgrade and there's no chef.openwrt.org.

 

[Aashish.007]

@wheatbread I meant chef.libremesh.org
I have already uploaded the latest snapshot with luci, adblock, upnp, tcpdump and attended sysupgrades for him.
Alternatively

https://asu.aparcar.org/store/f218798e34412a404851aef0772f5374/openwrt-73b4b4425c19-ramips-mt7621-tplink_archer-c6-v3-squashfs-factory.bin

 

[Fibrous]

Hello All,
Is it possible to change the 2.4GHz channel beyond 11 on the ARcher C6 V3.20? Stock firmware.

Any hack available other than changing firmware to the snapshot.

 

[nishantt6969]

@Fibrous I have purchased the same router but speed is not going above 350Mbps. Previously I was using Tenda AC1200 and was getting 500Mbps over wifi on the same devices. Any clue?

 

[imdarkray]

@nishantt6969 try enabling nat-boost.

 

[nishantt6969]

@imdarkray I couldnt find something named as nat boost, can you please navigate?

 

[nishantt6969]

In system parameters there is Nat and its enabled but I cant find NAT boost.