Hello all wanted to know is there any VOIP settings for AIRTEL xtreme fiber users if so how to access same using SIP settings ..thx
-
Amazon Deals - ToS - Like us?
Are VoIP Services or SIP Settings available in Airtel Xstream Fiber Broadband?
- Thread starter Arunesh Dutta
- Start date
- Replies 429
- Views 166,245
Add the voip interface to a firewall zone on openwrt, then add a traffic rule to forward any protocol from the voice wan zone to the internal ip address of the client in lan zone.
Images attached.
Upvote
0
@Soumil
It's working now for the most part. I got rid of siproxd and didn't have to setup any firewall rules. I think my issues were stemming from setting Username to [email protected]. Once, I switched that to +91xxxxxxxxx and proxy server/domain to ims.airtel.in, it's been working fine.
The only issue I have now is that with a Cisco phone, NAT KeepAlive enabled, I get error/warning messages (viewed using sipgrep) from the proxy 400 Bad Request - SS250200F133L1360[07130] Mandatory header absent.
Not sure how to get past this one - KeepAlive works fine from my SoftPhone client on my mobile (no such response received).
Edit: Seems to work now. There was a setting called 'Nat Keep Alive Msg' and it was set to $NOTIFY. I set it to blank and I no longer see the warnings. As far as i can tell, the keep alive messages are still being sent (seen using tcpdump and sipgrep).
Thanks for all your help with this
It's working now for the most part. I got rid of siproxd and didn't have to setup any firewall rules. I think my issues were stemming from setting Username to [email protected]. Once, I switched that to +91xxxxxxxxx and proxy server/domain to ims.airtel.in, it's been working fine.
The only issue I have now is that with a Cisco phone, NAT KeepAlive enabled, I get error/warning messages (viewed using sipgrep) from the proxy 400 Bad Request - SS250200F133L1360[07130] Mandatory header absent.
Not sure how to get past this one - KeepAlive works fine from my SoftPhone client on my mobile (no such response received).
Edit: Seems to work now. There was a setting called 'Nat Keep Alive Msg' and it was set to $NOTIFY. I set it to blank and I no longer see the warnings. As far as i can tell, the keep alive messages are still being sent (seen using tcpdump and sipgrep).
Thanks for all your help with this
Last edited:
Upvote
0
Can anyone make a condensed version and a complete step by step tutorial for Nokia G2425g.. I can understand only partially all the things discussed above. One more question Can we use this SIP profile in 2 Android phones(not at the same time) and make calls ? and does this work when not connected to the Airtel wifi and on mobile data ?
Upvote
0
These are my Airtel Xtreme fibre Nokia ONT router setting pics. There is no Authorization ID for voice profile. It won't allow me to change the routing mode to Bridge. VLAN binding options are not there nor is there a possibility to create an static ip route. Now I want to configure a SIP trunk for my IPPBX. So how do I get around this system? Please explain in very simple terms. I am not an expert at telecom. I am not even a techie..
Upvote
0
