IPv6 not getting assigned to android devices

  • Thread starter Thread starter Deleted member 83050
  • Start date Start date
  • Replies Replies 9
  • Views Views 5,003
D

Deleted member 83050

As the title says, IPv6 address is not getting assigned to android devices through my TP-Link Archer AX10. Assignment type is set to Auto and prefix delegation is enabled. ONT is set to bridge mode. Windows PC, iPhone, Macbook, ubuntu desktop and even Smart TV(WebOS and tvOS) is getting IPv6. I found a thread on openWRT forum which says
Google refuses to support DHCPv6 as per the standards. They ONLY allow SLAAC.
Link :IPv6 issue on android

Although this post is very old from 2018, i wonder if this issue still persists on android phones. When i was using the ONT provided by airtel as my primary router, there was no such issue.
Is there a workaround for this or am i missing something important?
 
Solution
Use slaac + stateless DHCP option in lan settings of your ipv6 page. Let the wan ipv6 settings be auto or dhcpv6.
Also update firmware to latest version.
EDIT: I just realized, you are not using OpenWrt.. For TP-Link stock under IPV6 settings, select DHCPv6+SLAAC
If there is no such option, select SLAAC only. Other device should work with SLAAC just fine, but often you won't receive IPv6 DNS.

Yes, this issue persists. You need to enable SLAAC.

From Luci Network > Interfaces > Interfaces

Edit LAN > DHCP Server > IPV6 Settings >
RA-Service > Server Mode
DHCPv6-Service > Server Mode
Local IPv6 DNS server > Tick
NDP-Proxy > disabled

Edit LAN > DHCP Server > IPV6 Settings > IPV6 RA Settings
Default router > Automatic
Enable SLAAC > Tick
RA Flags > M and O

Edit WAN > DHCP Server > IPV6 Settings >
Ensure everything under IPV6 is set to disable.
Edit WAN > Advanced Settings >
Delegate IPv6 prefixes > Tick
IPv6 assignment length > disabled
IPv6 prefix filter > -- please choose --

From Luci Network > Interfaces > Devices
br-lan > Configure... > Enable IPv6 > (Automatic)

And this should be good enough.
 
Upvote 0
@Lolita_Magnum Connectivity is very unstable when forcing it to SLAAC in IPv6 settings.IPv4 address is getting assigned to the router for a few seconds and then resets. Obviously not getting v6 address also. Hence unable to access the internet.
 
Upvote 0
IP address is getting reset on the router itself after forcing SLAAC. PPPoE dial up basically. Router gets disconnected from the internet. It seems Airtel doesn't allow SLAAC
 
Upvote 0
Back