No ADSL light blinking

[sagar2dumbre]

Hello guyzz.

i hv just brought my new router for my BSNL Broadband Connection ..name of that router is WA3002-g1...but i hv one problem ...all the router configuration has been done but still i don't get light at the ADSL ...it means POWER light is on,LAN & WAN light is also on..but ADSL light is not on...

in this way i hv connected router to my PC....

i hv got ADSL splitter ..it has 3 telephone on jack on both side...1 at one side and 2 at other side....i hv inserted main telephone line to 1 side of ADSL splitter....

remaining side of splitter 1 wire go 2 my telephone and other wire to WAN port of router....

UTP cable->one end to router and other end my LAN card....

plz reply its urgent....

--------------------------
i have also open diagnostic page ....it says ADSL synchronization Fail...and other test Fail.....

 

[essbebe]

Are you using a dialer to connect or BSNL told you,
you will get connected immediately.
Since you could see the Diagnostics page, Check in WAN page
whether your UserID is entered without @ bsnl.in if in PPPoE
mode.( If "Bridged" mode you have to use a Dialer )
Start Network LAn Properties TCP/IP properties.
Obtain IP address automatically Obtain DNS automatically Save.
TRY.
REF:WA3002-g1 ADSL MODEM (Type-II) MENU

Feedback.

 

[DrSRQ]

Hello guyzz.

i hv got ADSL splitter ..it has 3 telephone on jack on both side...1 at one side and 2 at other side....i hv inserted main telephone line to 1 side of ADSL splitter....


Dont' know about BSNL but Beetle splitter given by airtel has connections like this.

Single tele jack: for Phone Line, output from splitter to phone
Two Jack side: Upper one for Main Line, Lower one for Modem

 

[essbebe]

http://www.cable-trader.co.uk/images/adsl_splitter_premium.jpg
http://i34.tinypic.com/s4c0me.jpg (circuit diagram. Ignore link given)
Splitter mainly for Phone.

 

[sagar2dumbre]

Are you using a dialer to connect or BSNL told you,
you will get connected immediately.
Since you could see the Diagnostics page, Check in WAN page
whether your UserID is entered without @ bsnl.in if in PPPoE
mode.( If \"Bridged\" mode you have to use a Dialer )
Start Network LAn Properties TCP/IP properties.
Obtain IP address automatically Obtain DNS automatically Save.
TRY.
REF:WA3002-g1 ADSL MODEM (Type-II) MENU

Feedback.

UserID in 192.168.1.1 this site should be same as BSNL provided me ?
and whts dialer? ..i hv created new connection (without that ADSL light)...in new connection i have to used same username and password which BSNL provided me ?.....when i say connect it gives me Error 678

 

[essbebe]

when i say connect it gives me Error 678
Seems BSNL did not preconfigure the modem/router for you.
1. 192.168.1.1 is your Modem's access IP. user admin password admin
.... 2.usually.Bsnl . Gives example : UserID abcd @bsnl.in password 123zxyw
.......You enter this in the dialer I presume , and get error message 678.
3....... You should also get a 14digit portal ID and password
............as password to check your usage. Ask the exchange.
4............ Did you see the BSNL link I gave ? and recheck the settings ?
feedback.

 

---