Ppoe says connected but I'm not getting internet

  • Thread starter Thread starter itsudd
  • Start date Start date
  • Replies Replies 29
  • Views Views 1,984
itsudd

itsudd

Messages
38
Location
Udupi
ISP
BSNL FTTH
Hello...
I recently bought TP-Link xc220 g3v XPON varient....I configured everything.... Landline working smoothly and says connected in configuration page...Now the issue is that I configured internet settings the issue is in configuration page it says connected but internet light did not turned on...even if it's turned it will go off after few seconds.... I checked ppoe username and password, i entered it correctly...
What's the issue...
When I check it home page of modem it says configure dns manually....I did that too, still issue persist...
How to resolve....inputs from your sides are welcome
 
First, update the firmware from here. The site is TP-Link Russia but the firmware is in English. Then, I would suggest reset and configure VOIP first, then INTERNET. Also, is your current PPPoE MAC address the same that is bound to your connection?
 
Yes, I use the same firmware. MAC spoofing will work but you need to use the one that was used for PPPoE.
 
Make sure you have spoofed the mac of wan interface of the previous ONT. Lan MAC or system MAC spoofing wont work.
 
no. I meant to say, your previous ONT(modem) has different mac addresses for different interfaces, such as LAN1, LAN2..... LANx.
WAN, WLAN1,WLAN2......WLANx.

So you need to use WAN mac of older ONT in your new ONT(where you dial PPPoE).
 
You must log in or register to reply here.
Back