ACT Fibernet Bangalore - IPv6 setup question for TPLink Archer C1200 V3.0

[simon.george]

Hello,

I know that IPv6 works at my home with an openwrt router. (Basically with that router, on my windows pc, if I ping google.com, I am getting success replies from an IPv6 address)

I am wondering if the same will work with old TP-Link Archer C1200 V3.0 router. I tried below settings,

IPv6 - enabled
Internet Connection Type - PPoE
Get IPv6 address - Auto
Prefix Delegation - Auto
DNS Address - Get dynamic from ISP

Under LAN,
Assigned Type - DHCPv6


With above settings, my computer get an IPv6 address, however if I ping google.com, it still goes to IPv4 address
Tried ping -6 google.com, it resolved to an IPv6 address, but no success response.

 

[tr1k0N4]

Enable IPv6 on your Ethernet adapter.

 

[simon.george]

It already is.

 

[tr1k0N4]

Try using Test your IPv6.

 

[simon.george]

Shows No IPv6 address detected

 

[tr1k0N4]

Check on your mobile phone?

 

[simon.george]

same issue there too.

 

[tr1k0N4]

Try changing it to the following:
Get IPv6 address - DHCPv6
Prefix Delegation - Enabled

 

[simon.george]

Still no go, in LAN settings, Assigned Type is set as DHCPv6

 

[tr1k0N4]

Brdr, what router did ACT provide you?