well..........thnxx....:thumb::dance: ..bt there is another prob.....the headphones r working properly........bt still i cannot record sound..............i followed the similar procedure for red pin also bt it doesn't seem to wrk.....wt shud i do 
The same way as you checked the levels of the speakers, check the levels for the mic.
You must connect your microphone to the pink socket, not the line-in socket. Line-in is only for signals from line-out from other devices.
Also, make sure your mic input is not muted.
The above was the GUI method. If you want, you can try the command line method too:
You can list your recording devices by this command in a terminal:
$> arecord -l
It would helpful is you pasted the output of the above command here.
Now, if you have only one card listed (it will be numbered 0), then using the following command you can try to record a sample:
$> arecord foo.wav
press CTRL+C when you want to end recording (if you have multiple recording devices, then use "-c n" with the command where n is the number of device you want to use). Then you can play this sound in a player to see what got recorded. If the above command gives you an error, please paste that here as well.
BTW, I am assuming your microphone is working. Are you positive about this?
Regards.
The same way as you checked the levels of the speakers, check the levels for the mic.
You must connect your microphone to the pink socket, not the line-in socket. Line-in is only for signals from line-out from other devices.
Also, make sure your mic input is not muted.
The above was the GUI method. If you want, you can try the command line method too:
You can list your recording devices by this command in a terminal:
$> arecord -l
It would helpful is you pasted the output of the above command here.
Now, if you have only one card listed (it will be numbered 0), then using the following command you can try to record a sample:
$> arecord foo.wav
press CTRL+C when you want to end recording (if you have multiple recording devices, then use "-c n" with the command where n is the number of device you want to use). Then you can play this sound in a player to see what got recorded. If the above command gives you an error, please paste that here as well.
BTW, I am assuming your microphone is working. Are you positive about this?
Regards.