link light blinks green, then turns off, status: link down

[neevarp]

I found considerable changes in the SNR after i changed my wiring to finolex telephone cables. Yes, telephone cables do affect the performance of your broadband.

 

[essbebe]

@dheerajsp: 1.Could you connect DATAONE with your brother's Beetel 220BX. programmed? and access the Internet ?2. Could you access the Advanced page and check ADSL status for SNR etc ?!Let us not go to start of the thread Posting NO 1 by you ,and discuss line conditions again.

 

[Sheik Yerbouti]

thanx to a ****in' miracle and some experimentation and suggestions from here, everything is working on my Beetel modem!!! :hyper: :dance:thanx a lot... i tihnk enabling bitswap did the trick! though i still dont understand why!!!

 

[angry_s0ul]

I have a similar problem

MT882 and UL900 plan at Nellore, AP

I have reset the modem so auto dial is presently not configured and i connect by dialing from windows

Here is how it goes

Turn on the modem, green light starts blinking after about half a minute and then gets steady, but sometimes it goes off after a few seconds and then the blink to steady process repeats

sometimes its steady and i can use the net for hours but sometimes only for a few minutes and sometimes it goes on and off every few seconds

i have not observed any pattern in this, it happens any time of the day


there is something else which adds to the problem, the modem behaves like it has been turned on and off except that the power light stay always on and the on/off procedure is executed. (as if i have just turned on the modem, but the power light never goes off)
any stetting changes stay intact so this is not the reset procedure

here is the summary when it connects


http://img144.imageshack.us/img144/3293/summaryet3.png


and here is a print of ipconfig


http://img292.imageshack.us/img292/8675/ipconfighf4.png

i have configured the ip settings manually and set the DNS servers on the PC to open DNS

all modem settings are factory defaults

and btw thr is a lot of disturbance in the phone line but this too happens only sometimes not always

someone pls suggest something

 

[seshu]

^ please do not post the same query at different threads here .
however , one of the experienced members will try to solve it .

 

[neevarp]

@angry_soul Try changing the ADSL Modulation to ADSL 2+ or if possible to auto/multimode. And regarding the second part of your query, i think your modem is getting overheated. I too used to face the same, when it gets overheated and freezes up.

 

[angry_s0ul]

set the modulation to Multimode ad you suggestedhave to wait and see because this is an inconsistent and irregular problem i cant decide weather the change has resolved it or its just a few hours festivaland what do you suggest i should do for the over heating problem?

 

[neevarp]

Well that old mt882 burnt out due to heat problems. Now am on UTStar 300r2u, and it doesnt heat up that much.

 

[cisco_tech]

@cool_techie_tvm any idea where to get finolex cable ?

 

[neevarp]

Well i got them for free courtesy of Reliance. They had left an entire roll at my premises, when they came to install Broadnet. And when they didnt turn up for the roll, i decided to make good use of it. Coming to the matter at hand, they are available on all telephone (Land Phone) accessories shops in here.