Unable to access IPv6 on bridge mode

[ZeroTwo]

I'm unable setup IPv6 PPPoE on TP-Link Archer AX20/AX50
Please help!

 

[sloj]

Seems fine I guess. You have an IPv6 address on the last screenshot.

 

[ZeroTwo]

Everything seems fine on router side but I'm not getting any IPv6 address on PC/Mobile.
But with Syrotech Modem (Route Mode) I'm getting IPv6 without any issues.

 

[sloj]

Try SLAAC for PPPoE and rest same as before.

 

[ZeroTwo]

With SLAAC internet disconnected every 5 seconds.

 

[sloj]

Then DHCPv6 seems to be the correct one. Could be just a router issue. I had issue with my Digisol ONT too when using IPv6, it used to work for some time and then gateway goes missing for IPv6. Now I use a separate router but have kept IPv6 disabled. I did enable it yesterday to check and things were working fine.

 

[ZeroTwo]

Look like TP-Link Routers have broken firmware.
I tried with D-Link DIR-505 with OpenWRT installed and works fine.


upload pic


upload pic

 

[sloj]

Ya, I can confirm that it works just fine on Openwrt and doesn't require much configuration.