Which BSNL plan have you opted for?

[cyberswarup]

Ok guys today my plans just got changed and I regret not using 750 GB of my initial plans ;-; Damn it

I did speedtest to :
i3D HK
OVH Singapore
Bharti Airtel Chennai
Nforce Amsterdam
GTT New York

Earlier I had a combo of good/bad international speed over last few days.

Now that my plan is changed to 200 mbps, I'm getting hard-capped 95 Mbps. My speedtests shoots upto 75-88 very fast for most of them and slowly approaches 95 Mbps.

For some servers it slowly builds upto 95 like start from 35 mbps upshoot and gradually climb upto 95mbps.

Altho' it's not promised 200mbps atleast it's consistent 95 Mbps everywhere

My pings tho worse than when I first got FTTH connection are relatively better than others here to international servers for e.g. HK is 120-130 ms, Nforce Amsterdam is 167 ms etc, SGP is 90 ms(earlier it was tight 75 ms)..

DNS pings are worse than earlier as both G-DNS and CF-DNS were <20 ms for me now GDNS is somewhere between 17-24 ms and cloud flare is 40-42 ms

Total Data consumed in speedtest is 1.992 GB

Same with me. My plan got changed to 200 mbps, but maximum speed I get is only around 95 to 100 mbps (both LAN and wifi). Any solution to this? Thanks

 

[shashankb]

@cyberswarup Are you sure you used a Gigabit port on both ends to try out the LAN speedtest ?

 

[cyberswarup]

I have checked with both the ports of modem, also my laptop receives upto 300 mbps when connected to my office internet

 

[sloj]

80 ms
I get 5 ms to 8.8.8.8

It's been bad since yesterday. I always get connected on 117.x.x.x. Normally I would get 40-ish ms. Speed is fine though.

 

[sloj]

I have checked with both the ports of modem, also my laptop receives upto 300 mbps when connected to my office internet

So your laptop port is gigabit?

 

[shashankb]

Even if the Port on the Windows machine is Gigabit it is disabled for 1 Gig duplex sometimes .. be sure to check with that
The Ethernet link properties shows 1.0 Gbps if everything is at correct setting

 

[sloj]

By default it should be auto-negotiation.

 

[shashankb]

But in my Windows even after plugging it into a Gigabit port of a Router ...it still took a 100 Megabit link . So had to change it manually

 

[sloj]

Weird but if that fixes it for him then nice I guess.

 

[cyberswarup]

I have checked with my laptop at office today and got around 270 mbps there. But with the same setting I doesn't cross 100 mbps at home (BSNL). May be my speed is capped at 100 mbps by BSNL. I have talked with my LCO and he will tell something tomorrow about the problem.