How to Get Airtel's Backend to enable Bridge Mode

XU32

XU32

Messages
10
Location
Pune
ISP
Airtel
Folks,

I see a lot of you have been successful in getting Airtel's Backend to enable the bridge mode on your connections. I have been at it for the past 4 days and I am yet to encounter a knowledgable individual at Airtel's Call Center. I have escalated it to the Nodal email provided and I am hopeful they get this done.; however, I wanted to pick your brains on how you managed to enable the Bridge Mode.

Any advice / guidance is much appreciated.

Thanks

PS: Anyone tried re-flashing the Nokia G-2425G-A? If you have any advice / guidance please DM/PM. Cheers
 
Sort by date Sort by votes
I had same opinion till i tried openwrt router.
Stock firmware sucks on most routers imo.
 
Last edited:
Upvote 0
For some reason bridge mode increased the latency by 7-10 ms, so i gave the request to disable bridge mode on thursday and it was disabled yesterday. Is it normal for latency to increase in bridge mode?.
 
Upvote 0
droid said:
but i am in bangalore and no CG-Nat yet , so may be ipv6 not enabled yet.
Click to expand...
I am from tier 3 city in karnataka and i was getting ipv6, when the connection was in bridge. I am not getting ipv6 right now because the wan configuration is set to "ipv4". Check the post where i shared the pic of getting ipv6 in my Netgear router.
 
Upvote 0
You must log in or register to reply here.

Similar threads

M
  • Article Article
How to enable bridge mode on Airtel Xstream Fiber?
2 3 4
Replies
39
Views
10,053
vsgarg
Back