Netplus router admin Access and unlock Router (ZTE ROUTER)

  • Thread starter Thread starter Harmanpreet
  • Start date Start date
  • Replies Replies 37
  • Views Views 23,269
Messages
61
Location
Amritsar,Punjab
ISP
Airtel Xstream Fiber
Netplus
here's how you unlock router and gain access to admin account,unlocking the router's firmware (router-ZTE f660 or ZTE f670l)
1.Access Telnet (you might need additional stuff to get telnet creds,msg below if you want guide on that)
2.after accessing telnet,enter this command - upgradetest sdefconf 198
after that,country code of router may change and you may get message of success or nothing but router will restart
if it restart that means it got unlocked
Now you can access admin account,
username will be admin
password will be admin or Web@0063

this worked for me and i hope it does for you too
Note you have unlocked ont so that does mean you can use ur ont with any other provider by just going to telnet and using
setmac show -command to change the values
setmac 1 <id> <value> to add
setmac 3 <id> to delete
(i personally tested this with netplus and airtel router and this works by changing GPON sn,gpon password and mac address)

Please note i have no intention to promote any bad stuff or anything like that,i am just normal consumer who wanted access to all router but company rejected it by ignoring me,for which i paid 2500 for connection and still had to buy rs.4000 additional router to get control over settings and i dont want any other person to struggle on this.
 
Solution
I figured out how to put F670L into Bridge Mode (Working on Green or V1) Test it on Blue V9 and let me know,
Just run this comand when after opening WAN and Right click > Inspect > console > paste the command below (After saving route will change to Bridge Connection) 🙏👍
"document.getElementById('Frm_mode').options[document.getElementById('Frm_mode').options.selectedIndex].setAttribute('value', 'BRIDGE');<br>Change_mode();"
Hi, I'm facing following error for my NetPlus / Fastway Modem. I think user:user isn't enough to do factory reset ? If that's the case, How do I obtain admin level credentials ? I've tried following combination too, but didn't work:

admin:admin
admin:Web@0063
admin:Web@0763
user:Web@0763
user:Web@0063

Please help!

c:\Temp\ztelnet-main>factorymode_crack.exe -l xxx open -i 192.168.1.1 -u user -pw user
version:3.1
CheckLoginAuth.gch WebRecv Fail!
SendSq.gch WebRecv Fail!
Enter 192.168.1.1 Telnet FactoryMode Fail!

My Modem details are:

Model F670L
Hardware Version V1.1.01
Software Version V1.1.20P11N1B
Boot Loader Version V1.1.20P10N2
 
Last edited:
Upvote 0
hii iam fahim i trying to open telnet but showing error tis command not exites can you help me
 
Upvote 0
Router is Unlocked i have set up the ISP settings to run internet, i am using NetPlus so i want to enable their Net+Roaming that need bridge to work and setup , sooon will be changing back to BSNL after 1st date next month and will use this Zte Router as a Extender
 
Upvote 0
What's stopping you from enabling Net+Roaming? Create a Bridge Mode WAN profile with VLAN 99 and bind it to one of the SSIDs.
 
Upvote 0

Back