Low Speeds on Archer C6 V3.20 during bridge mode.

[nishantt6969]

I used to get 400+ Mbps on wifi on my previous router(Tenda AC1200) but since I have purchased TP-Link Archer C6 V3 and using dragonpath ont in bridgemode the speed I am getting is less than 400Mbps and it also fluctuates. When I connect Archer C6 to ont via ethernet(non bridged) the speeds I am getting is good and above 450Mbps+. What could be the possible issue?
Thanks for reading.

 

[rohitks]

Is Tenda1200 still with you? What fi you go back to that Tenda? Are speeds back to 400.

When I connect Archer C6 to ont via ethernet(non bridged)

By non bridged do you mean as an access point?

 

[nishantt6969]

@rohitks Tenda in AP mode brings 450+
bridge mode with static IP doesnt work on Tenda.

 

[Baby Clasher]

Same with my C6 V3.20
When umI reset my router it works fine for 2-3 days then again fall back to 180-220 Mbps Max.
What could be the problem?
Although my AX1800 Works Perfectly.

 

[GR2]

Enable nat boost

 

[Baby Clasher]

And how to do this? There is no option for NAT boost as shown in YouTube. The feature has been disabled by TP-Link for C6 V3

 

[nishantt6969]

I dont understand why people are suggesting to turn on NAT boost as there is nothing like NAT Boost.

 

[Baby Clasher]

@nishantt6969 I have seen same issues as ours on TP-Link forum but all they say is check device, check other stuff etc. But no straight answer.

 

[GR2]

It's basically nat acceleration. It was there before. No idea when and why they removed it

 

[nishantt6969]

Maybe indian version of the firmware doesnt have nat boost. What if we flash some foreign firmware?