Hi everyone,
I recently requested Airtel to activate Bridge Mode on my Xstream Fiber connection so I can use my own TP-Link XC220-G3V (AC1200) as the main router.
The backend team pushed the configuration, but I am completely unable to establish a PPPoE connection.
My Setup:
The Suspect (Screenshot Attached): I managed to log into the Airtel ONT's admin page, and while I can see the connection mode is successfully set to Bridge mode with Profile: 1_TR069_INTERNET_B_VID_100, the LAN Port binding checkboxes are completely blank/unchecked and greyed out by the firmware.
My Question:
I recently requested Airtel to activate Bridge Mode on my Xstream Fiber connection so I can use my own TP-Link XC220-G3V (AC1200) as the main router.
The backend team pushed the configuration, but I am completely unable to establish a PPPoE connection.
My Setup:
- Airtel Xstream ONT (LAN 4) -> TP-Link WAN Port.
- PPPoE username and password have been double-checked with an Airtel employee.
The Suspect (Screenshot Attached): I managed to log into the Airtel ONT's admin page, and while I can see the connection mode is successfully set to Bridge mode with Profile: 1_TR069_INTERNET_B_VID_100, the LAN Port binding checkboxes are completely blank/unchecked and greyed out by the firmware.
My Question:
- Am I correct in assuming the Airtel NOC enabled the bridge profile but forgot to actually bind the signal to LAN 4, meaning the port is effectively dead?
- It'd be really nice if you could also share your WAN configs if you've enabled bridge mode on your Airtel Xstream.
Last edited: