BSNL FTTH Netlink firmware and bridge mode

[Sanemi]

@ZeroTwo Did you clone the TEC certified ont credentials to the Huawei ont (GPON S/N) ? and use the wan mac of old ont to your router ?

 

[ZeroTwo]

@Sanemi I didn't clone anything on Huawei ONT.
I just put the ONT on bridge mode, tagged VLAN and I cloned TEC certified MAC series on router.

 

[Sanemi]

@ZeroTwo What was your primary configuration/setup by bsnl(lco) ?

 

[ZeroTwo]

@Sanemi They provide me Single Band Syrotech SY-GPON-1110-WDONT but after few months I change to Huawei HG8120C ONT and TP-Link Archer AX50 and now I'm using Huwaei HG8321R ONT and Asus TUF Gaming AX-4200

 

[Sanemi]

@ZeroTwo So what are the steps to convert the Syrotech ont to Huawei ont .
Is it just vlan taging on ont and mac cloning on router ?

 

[!!..PD..!!]

@ddpk There will not be 3 profiles on ONT when you want to use PPPOE on router.
You need to delete the third profile and use one of the the two profile in bridge and other for landline. Also, verify that none of these two profiles have the PPPOE registered MAC addresses assigned.
When I do a reset on ONT and load the saved configuration then the mac addresses also get reset on the ONT

 

---

[ZeroTwo]

@Sanemi Yes!
Just put on bridge mode and tag VLAN and PPPoE profile on router with cloned MAC.

 

[Sanemi]

@ZeroTwo That’s interesting I’m wondering what OLT authentication was done on your LCO side normally it’s GPON s/n or for EPON it’s MAC address

Btw it’s GPON connection right ?

 

[ZeroTwo]

@Sanemi Mine is EPON with no authentication.
For GPON you need to clone GPON S/N on Huawei ONT

 

[ddpk]

@!!..PD..!! - yes I made sure that the mac id that I copied was of the 3rd profile and i deleted that profile on ONT and the 2nd profile is in bridge with another mac and 1st profile is using voice . Do i need to tell the bsnl office to reset my Mac again?