This is strange, I have configured the Nokia ONT(G140WF) to bridge on LAN Port 4, which connects to my OpenWRT Archer C-20 running YATE for Airtel's VoIP calls. I have had no issues whatsoever when connecting to the SIP system, but configuring PPPoE on the Archer fails with the PPPoE Active Discovery Packets getting lost. Anybody has a hint of what's wrong?
-
Amazon Deals - ToS - Like us?
Nokia G-140W-F bridge mode?
- Thread starter rajil.s
- Start date
- Replies 225
- Views 142,252
gopichandpai
Regular
I am trying to configure my Asus router after changing the LAN 4 port of Nokia G-2425G-A to bridge mode. When I connect the LAN 4 of Nokia to WAN port of my Asus router, it says network cable is unplugged(something like LAN 4 port got disabled and WAN port of Asus router is not getting any power). If I connect LAN 1/2/3 which are still in route mode, WAN port of Asus router is getting the power. I am yet to call Airtel to enable the Bridge mode from the backend. Did anyone have this issue?
@gopichandpai What do you mean by unplugged? Have you enabled VLAN tagging and set the internet ID to 100. The bridge mode only worked for me after I did the VLAN tagging.
@gopichandpai I have the same Nokia model and enabled bridge mode for Lan 4 and it works with my Asus router without issues. I didn't request airtel to enabled it from backend. It worked out of the box.
gopichandpai
Regular
Thanks Guys. @social3467 I haven't done the VLAN tagging. I have this screen under vlan binding and I am not sure what to do here.
When I choose LAN4 and user-side VLAN as 100 and connection name choose on WAN from the drop down then I get the error message please bind a WAN.
Under WAN there is no option to create a new profile either.
@Gokul Kannan you had to just configure pppoe or you configured anything under iptv section?
When I choose LAN4 and user-side VLAN as 100 and connection name choose on WAN from the drop down then I get the error message please bind a WAN.
Under WAN there is no option to create a new profile either.
@Gokul Kannan you had to just configure pppoe or you configured anything under iptv section?
Just got a call from Airtel that fibre is now available in my area. Have asked them some time while I figure out I will be able to bridge it as cannot afford to network all my stuff again. I have 2 EAP access points and was planning to buy Edgerouter X (current router runs Openwrt router).
But before that, "man me soojhi shaitani". If we can get two connections dialed up, can we do wan aggregation and get double the speed?
But before that, "man me soojhi shaitani". If we can get two connections dialed up, can we do wan aggregation and get double the speed?
gopichandpai
Regular
@Gokul Kannan if time permits could you please add the screen shot of your iptv section?
@social3467 could you please help me with vlan tagging?
@social3467 could you please help me with vlan tagging?
I will share the screenshot later today.
Under IPTV section select Manual from the list of options and
Add 100 as the VLAN Id and leave priority as 0 to Internet
Then apply the settings.
Under IPTV section select Manual from the list of options and
Add 100 as the VLAN Id and leave priority as 0 to Internet
Then apply the settings.
Similar threads
- Question
