VOIP softphone setup with just ONT and nothing else.

[sloj]

BSNL Ftth voip config in IP phone | BSNL Bharat Fiber Broadband

I think IPs may change according to location. I am from kerala so mine might be configured to connect to BSNL's systems for my area. Also, you shared voice interface(IPoE) details and I shared internet (PPPoE) details. It doesn't allow me to see the IPoE settings like it shows PPPoE settings.

broadband.forum

After this was posted, I looked again at my voice WAN config and realized its Service Mode was set to VOICE. So I changed it to VOICE_INTERNET and voila I can ping the voice gateway but not SIP server. So a static route needs to be made. Network -> Router -> Static Route and do the necessary changes.

Destination is the SIP server address, Gateway is voice gateway. And we are connected.

Things I did differently than the linked post. Disabled SIP under Application -> ALG configuration. Routers SIP ALG - VoIP-Info.

Updated Here

 

[soumyadeep.chelsea.bhowal]

some other stuff works fine.....like change dns,etc only when i do something to the wan it just hangs...

 

[PranjalT]

why? you're not able to login? you have to reset the password using Syro@43210$ and login with the new password. first disable the route then delete it.

 

[soumyadeep.chelsea.bhowal]

no it works....i have to restart the router and then it works...but I can't change anything in wan that's what

 

[soumyadeep.chelsea.bhowal]

did you perform hard reset and checked?

 

[PranjalT]

nope, I just did soft reset twice not hard. you can try this- remove the fiber patch cable and then try removing that route.

 

[soumyadeep.chelsea.bhowal]

no..it didn't help...

 

---

[shin]

The firmware is garbage. If you try to remove static route the router freezes, and the reset button on the router didn't work for me.
I reset using the web config. Used the factory reset or something

 

[soumyadeep.chelsea.bhowal]

yes i've tried.....but the thing is i've saved my config file after this problem happened....so will have to manually config again...

 

[soumyadeep.chelsea.bhowal]

don't know if i will ever going to make calls from my pc.....

 

[PranjalT]

You can try login to the device through ssh or telnet and disable the routes from the CLI.

config route delete <ip add> mask <subnet mask>